Page 22
Voyager User’s Manual - The Components
Page 23
Voyager User’s Manual - The Components
3 KB Cont (Oscillator 3 Keyboard Control):
The
3 KB CONT
switch disables keyboard control of Oscillator 3 when in the OFF position. By disabling
the keyboard control, you can use Oscillator 3 as a drone or as a modulation source whose frequency
doesn’t change with the key played. In addition to turning off the keyboard control of Oscillator 3, switching
to OFF increases the amount by which the Oscillator
FREQUENCY
control changes Oscillator 3’s
frequency.
3 Freq (Oscillator 3 Frequency):
The
3 FREQ
switch selects Oscillator 3’s frequency range. When the switch is in the LO position, Oscillator
3 operates as a subaudio sound source (producing clicks) or as a modulation source (LFO). When the
swicth is in the HI position, Oscillator 3 operates with the same available frequency range as Oscillator 2.
Related Oscillator Controls:
Two other panel controls interact with the Voyager Oscillators: Fine Tune and Glide. These controls are
located in the lower left of the Voyager’s front panel
Voyager
Keyboard
Voyager
RME
Fine Tune:
The
FINE TUNE
control is used to tune the Voyager’s oscil/ – 2 semitones for matching an external
reference pitch.
Glide Rate:
Glide enables a glissando effect between notes. The
GLIDE RATE
control adjusts the rate of the glissando.
The glide rate can vary from a very fast to a very slow glide. It can be switched on or off using the
GLIDE
switch in the Voyager keyboard left-hand controller section, or in the PANEL mode menu of the RME. You
can also turn glide on or off by sending a MIDI CC 65 message (0-63 = off, 64-127 = on).
