Money Controls Ardac IBA5, Руководство по спецификациям и регулировке

Страница: 53 / 72

Specification and Adjustment Manual - ARDAC IBA5
Document Number 44X501R2 – March 15, 2004
5-1
5. 5
Maintenance
Introduction
The Money Controls Imbedded Bill Acceptor System 5 (IBA5) provides maximum performance with a
minimum of service and maintenance. Typical maintenance consists of periodic inspection and cleaning of:
- Sensor Surfaces
- Drive Components
- Note Path Components
Adjustments
The IBA5 sensors are self-adjusting and do not require routine electronic calibration.
Cleaning
Bank note handling devices normally build up a film of oil and dirt from the bank notes themselves. The
IBA5 has been designed to operate for extended periods of time between cleanings. If excessive dirt builds
up on the transport drive mechanism or sensors, poor acceptance may result. The note path should be
cleaned at least once a year. More frequent cleaning may be required depending on the location, frequency
of usage, and condition of the notes taken in.
Cleaning Materials
CAUTION
OIL-BASED SOLVENTS WILL ATTACK RUBBER PARTS, CAUSING PREMATURE
FAILURE. AGGRESSIVE AROMATIC SOLVENTS WILL ATTACK OR MELT PLASTIC
COMPONENTS AND PAINT
When cleaning the IBA5, use the following materials:
- Clean, soft lint-free clothes
- 70% or greater Isopropyl Alcohol