Money Controls Ardac IBA5, Руководство по спецификациям и регулировке

Страница: 56 / 72

Specification and Adjustment Manual - ARDAC IBA5
Document Number 44X501R2 – March 15, 2004
5-4
Method 2
Using Cleaning Card Mode
1. Setting switches on the micro board enters the cleaning card mode. (See switch setting table in
section 1)
2. Set unit into cleaning card mode according to switch settings in section 1.
3. Install unit into host machine and apply power.
4. Wait for stacker to cycle out and back two times.
5. Insert Money Controls 49X315 cleaning card while holding end of cleaning card firmly.
6. The motors should run for approximately 6 seconds.
7. Do not allow the entire card to be pulled inside machine.
(The belts should be moving while card is held stationary)
8. If the cleaning card does accidentally slip into the machine, it will be returned to you.
9. The card should be inserted in all four directions to assure adequate cleaning of belts.
(It is normal to see black marks on the cleaning card from the dirt on the acceptor belts.)
10. After running the cleaning card, open the unit and wipe the note path with a cloth to clear any
remaining debris from the note path. (Dampen cloth with alcohol if required to remove foreign
material)
11. After cleaning, turn cleaning card mode off with the DIPswitches.