Money Controls Ardac IBA5, Руководство по спецификациям и регулировке

Страница: 26 / 72

Specification and Adjustment Manual - ARDAC IBA5
Document Number 44X501R2 – March 15, 2004
2-5
Refer to Figure 2-1 and replace the old EPROM with the new one:
1. Make sure all power is disconnected from the microprocessor board.
2. Note the orientation of the EPROM and the pin-1 notch, compared to the illustration in Figure 2-1.
3. Using a small needle nose pliers, loosen one end of the EPROM and then the other. Pull the EPROM from
its socket. (Observe proper ESD protection procedures)
4. Position the new EPROM over the socket with the notch in the EPROM at the pin 1 end of the socket. This
is the end of the socket closest to the DIP Switches.
5. Make sure all of the pins are straight and aligned with their respective sockets.
6. Be careful to prevent bending the pins or damaging the EPROM, press the EPROM into its socket until it
seats firmly.
Check the DIP Switch Settings And Re-set As Required
The microprocessor board used in the IBA5 note acceptor has two banks of eight DIP switches. These
switches set the System’s operating mode and enable or inhibit acceptance of certain notes. They are
located on the Microprocessor Board as shown in Figure 1-11. Refer to Table 1-1 and verify that the DIP
switches are set properly for the required mode of operation and currency combination. If changes are
required, use a small non-conductive screw driver or plastic switch setting wand to toggle the switches. Do
not use a conductive probe of any kind.
Insert Stacker Module into the Chassis
To assure proper operation of the IBA5, the stacker cassette must be fully installed and locked into position
before the System is powered up.
When inserting the stacker cassette into the chassis:
1. Position the back of the cassette between the guide rails at the bottom of the chassis. (Fig. 2-2)
2. Make sure the latch pin on the right side of the stacker is under the stacker retaining latch on the right side
of the chassis.
3. If the note acceptor has already been inserted into the chassis, note the stacker punch gear at the top front
corner of the cassette. Also note the punch drive gear at the bottom front corner of the note acceptor. Make
sure these gears mesh properly and without damage as the stacker cassette slides into the chassis.
4. Carefully push the cassette into the chassis until it seats against the back of the chassis, and the stacker
retaining latch catches the latch pin.
Insert Note Acceptor Module
To assure proper operation of the IBA5, the note acceptor module must be properly positioned, locked in
place, and the main harness connector of the acceptor must be fully inserted into its mating connector in the
chassis. The acceptor unit makes or breaks all connections when the acceptor is installed or removed from
the chassis.
When inserting the note acceptor into the chassis:
1. Position the back of the acceptor so the support rails at the top of the acceptor fit above the guide rails at
the top of the chassis.
2. If the cassette stacker has already been inserted into the chassis, note the stacker punch gear at the top front
corner of the cassette. Also note the punch drive gear at the bottom front corner of the note acceptor. Make
sure these gears mesh properly and without damage as the acceptor slides into the chassis.