Money Controls Ardac IBA5, Руководство по спецификациям и регулировке

Страница: 55 / 72

Specification and Adjustment Manual - ARDAC IBA5
Document Number 44X501R2 – March 15, 2004
5-3
Cleaning Instructions
Method 1
Using cloth and 70% or higher alcohol solution:
1. Turn off power to the System.
2. Locate the release tab on the left side the acceptor. Press the tab upward, and while
maintaining pressure on the tab, slide the note acceptor out of the chassis (Figure 5-1).
3. Open the acceptor by simultaneously pushing inward the acceptor cover releases tabs on
either side of the acceptor. While maintaining pressure on the release tabs, swing the top
cover open to expose the note path and sensors. (Figure 5-1)
4. Inspect the condition of the belts, gears and sensor surfaces in the bottom sensor plate.
The belts should not be frayed, glazed, nicked, or worn. Also inspect the rollers in the top
sensor plate. Rollers should be smooth and not show signs of wear, abrasion, or other
damage.
5. Check the condition of the sensor windows and grays scales in the top and bottom sensor
plates. These surfaces should not be worn, scratched, or discolored.
6. Dampen a lint-free cloth with 70% or higher isopropyl alcohol. Make sure the cloth is
not soaked so much that alcohol will drip from it into the acceptor. Wipe the inside of
the note path. Make sure to clean pressure wheels on top, belts, windows and gray-scale
plastic. After exposed portion of belts are cleaned, rotate large black gear on rear of
acceptor to expose the portion of the belts that have not been cleaned and repeat cleaning
until all of belts are clean.
7. Locate the other note sensor sets in the top and bottom sensor plates. Use a cotton swab
moistened with alcohol the sensors if required.
8. Routine lubrication of this product is not required.
NOTE:
Do not clean small round sensors unless a film or dirt is visible on the lens