4
73D4125
KSTDV Series Gas Fireplace
IMporTanT SaFeTy InForMaTIon & coDe approVal
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the
National Electrical
Code, ANSI/NFPA 70
, or the
Canadian Electrical Code,
CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
17. When the appliance is installed directly on carpeting,
tile or other combustible material other than wood floor-
ing, you must set appliance on a metal or wood panel
or hearth pad extending the full width and depth of the
appliance.
18. Do not use fireplace if any part has been exposed to
or has been under water. Immediately call a qualified
service technician to inspect the appliance and replace
any part of the control system and any gas control which
as been submerged in water.
19. Do not operate fireplace if any log is broken.
20. Do not use a blower insert, heat exchanger insert, or
any other accessory not approved for use with this
fireplace.
21. Do not operate the fireplace with glass door removed,
cracked, or broken.
coDe approVal
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT
VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
lISTeD VenTeD GaS FIreplace heaTer
TESTED TO: ANSI Z21.88b-2008/CSA 2.33b-2008 STANDARDS
A manufactured home (USA only) or mobile home OEM installation must conform with the
Manufactured
Home Construction and Safety Standard,
Title 24 cFr, part 3280,
or when such a standard is not appli-
cable, the
Standard for Manufactured home Installations, anSI/ncSBcS a225.1
, or
Standard for Gas
equipped recreational Vehicles and Mobile housing, cSa Z240.4
.
WARNING
!
HOT GLASS
WILL
CAUSE BURNS.
DO NOT TOUCH
GLASS
UNTIL COOLED.
NEVER
ALLOW CHILDREN
TO TOUCH GLASS.
w
arn
In
G
never connect unit to private (non-utility)
gas wells. This gas is commonly known
as wellhead gas.
IMporTanT:
pleaSe reaD The FollowInG
careFully
It is normal for fireplaces fabricated of steel
to give off some expansion and/or contraction
noises during the start up or cool down cycle.
Similar noises are found with your furnace heat
exchanger or car engine.
IMporTanT:
pleaSe reaD The FollowInG
careFully
It is not unusual for gas fireplace to give off
some odor the first time it is burned. This is due
to the manufacturing process.
please ensure that your room is well
ventilated during burn off — open all
windows.
It is recommended that you burn your fireplace
for at least ten (10) hours the first time you use
it. Place the fan switch in the “OFF” position
during this time.
Содержание KSTDV500
Страница 48: ...48 73D4125 KSTDV Series Gas Fireplace ...
Страница 49: ...73D4125 49 KSTDV Series Gas Fireplace ...
