MMP LIFTEM MARK IV, Руководство по эксплуатации

Страница: 44 / 52

M I L L E N N I U M M E D I C A L P R O D U C T S , I N C .
41
When LIFTEM is Disassembled for Transport or ACTUATOR Change
Apply Food-Grade Teflon Anti-Seize Lubricant (McMaster-Carr Part Number 1404 K11) to the Teflon
thrust bearing using the following procedure (see photo):
•
Remove the two acorn nuts that hold down the “L” SHAPED BRACKETS to the MAST
RETAINER.
•
Loosen the two screws that hold the “L” SHAPED BRACKETS to the MAST using a 3/16 Allen
Hex Key and slide them out of the way. Temporarily tighten.
•
Remove the four hex head screws that hold down the MAST BUSHING CLAMP PLATE and
remove the two CLAMP PLATES.
•
Push back on the MAST in the direction away from the legs and pull out the FRONT MAST
BUSHING.
•
Lubricate the vertical bearing surface of the FRONT MAST BUSHING using the lubricant specified
above.
•
Push the MAST in the direction away from the legs and replace the FRONT MAST BUSHING.
•
Replace the two MAST BUSHING CLAMP PLATES and screws.
•
Loosen the screws and slide down the “L” SHAPED BRACKET down the MAST over the screws
left protruding out of the REAR MAST BUSHING. Retighten the screws holding them to the
MAST.
•
Replace and tighten the two acorn nuts.
Quarterly Service and Maintenance
On a quarterly basis, connect LIFTEM to 115 Volt AC MAINS for complete BATTERY charging.
Triennial Service and Maintenance
Every three years replace “O” Rings on all connections to the CB14 CONTROLLER using LINAK “O”
Rings. Lubricate “O” Rings with white Vaseline to facilitate installation. Insure that the socket is clean
and undamaged.
Quadrennial Service and Maintenance
Every four years replace the BATTERY with a new unit. Return the BATTERY to MILLENNIUM
MEDICAL PRODUCTS for proper disposal.