MMP LIFTEM MARK IV, Руководство по эксплуатации

Страница: 40 / 52

M I L L E N N I U M M E D I C A L P R O D U C T S , I N C .
37
retracted.
4) Measure distance from TOP of the MAST to CHEEK PLATE upper mounting BOLT CENTER
LINE.
5) Measure distance from CENTER to CENTER WIDTH between REAR CASTER mounting
BOLTS.
6) Verify presence of required decals and tags.
e) Operational Test:
The purpose of the Operational Test is to verify that LIFTEM continues to meet its basic functional
requirements. Record all results on the Data Sheet.
1)
Setup LIFTEM to operate.
2) Lock REAR CASTERS. Using HANDSET; Extend LEGS fully.
3) Measure distance from FRONT END of LEGS to BACK of BASE Lip with LEGS fully
extended and not spread.
4) Using HANDSET; Spread LEGS fully.
5) Measure CENTER to CENTER WIDTH between FRONT CASTER Mounting BOLTS.
6) Position the BOOM in the CENTER and Lower the BOOM until it stops.
7) Measure distance between FLOOR and 600-Pound LIFT POINT HOLE CENTER.
8) Raise the BOOM until it STOPS. LIFT ACTUATOR should have traveled to its full extension.
9) Measure distance between FLOOR and 600-Pound LIFT POINT HOLE CENTER.
10) Measure extension of the LIFT ACTUATOR from the GROOVE near END of the PISTON
SHAFT to FRONT of CAP on LIFT ACTUATOR HOUSING.
11) Inspect the LIFT ACTUATOR Piston Rod Eye, Bushing and Case Back Fixture for wear. (See
LIFTEM Figure 8, Page 49.)
12) Inspect the inner and outer tubes of the LIFT ACTUATOR for deep scratches or dents. (See
LIFTEM Figure 8, Page 49.)
13) Rotate the BOOM FULLY LEFT & FULLY RIGHT, 30° each way.
14) Return the BOOM to the CENTER POSITION and LOWER.
15) RETRACT and CLOSE LEGS.