Mitsubishi MOTORS OUTLANDER SPORT/RVR 2022, Руководство пользователя

Страница: 359 / 535

(358,1)
[ Edit: 2021/ 2/ 10 Model: DG-D ]
5-108
Starting and driving
to reduce the distance to vehicle directly ahead.
Only the left side turn signal operates this
feature. As the driver steers the vehicle and
moves into the passing lane, if no vehicle is
detected ahead the ACC system will continue to
accelerate to the set vehicle speed. If another
vehicle is detected ahead, then the vehicle will
accelerate up to the following speed of that
vehicle. If the vehicle is not steered into the left
lane to pass, the acceleration will stop after a
short time and regain the set following distance.
Acceleration can be stopped at any point by
depressing the brake pedal or the CANCEL
switch on the steering wheel.
WARNING
In order to reduce the risk of a collision that
may result in serious injury or death, please be
aware of the following:
.
This function is only activated with the left
turn signal and will briefly accelerate the
vehicle even if a lane change is not
initiated. This can include non-passing
situations such as left side exits.
.
Ensure that when passing another vehicle,
the adjacent lane is clear before initiating
the pass. Sudden changes in traffic may
occur while passing. Always manually
steer or brake as needed. Never solely rely
on the system.
Speed Limit Assist - a feature of MI-
PILOT Assist with Navi-link (if so
equipped)
WARNING
Listed below are the system limitations for the
Speed Limit Assist. Failure to operate the
vehicle in accordance with these system limita-
tions could result in serious injury or death:
.
It is the driver’s responsibility to select the
proper speed, follow all traffic regulations
and observe other road users.
.
The Speed Limit Assist may not operate
properly and the actual speed limit may
not be applied to the vehicle set speed in all
conditions. The driver must manually
control the vehicle speed.
— When the Traffic Recognition
Sign (TSR) system is not function-
ing properly or turned off. (See
“Traffic Sign Recognition (TSR)”
(P.5-30).)
— When driving in countries or
areas not covered by the naviga-
tion system.
— When crossing national bound-
aries.
— When driving on the exit of the
limited access freeway as identi-
fied in the navigation map data.
— When driving in an area with
nearby parallel roads (for exam-
ple, freeway with a parallel ser-
vice drive).
— When driving in an area where
each lane has a different speed
limit sign.
— When driving on a road under
construction or in a construction
zone.
— When the data from the naviga-
tion system is not up-to-date or is
unavailable.
When the MI-PILOT Assist with Navi-link is
active and it detects a change of the speed limit,
the new speed limit sign is indicated and it can
be applied to the vehicle set speed automatically
or manually.
The Speed Limit Assist operates:
. When the detected speed limit sign is 20
MPH (30 km/h) and above.
. The “Spd. Limit Assist” is enabled in the
settings menu of the multi-information
display.
Condition: