REV 1.4
47
1.8. Display memory setting
Used to set the output image on screen when it is used as a multi-screen or the display position of the
output image requires some adjustments.
There is no need to register the display memory when the input board is not attached. In this case,
the menu 2 for the memory setting up is not displayed.
Note: Even if the adjusted values in input memory via the input board are the same as the
ones via the main unit, the display memory is required to save newly.
1.8.1. INPUT
MEMORY
Used to designate the input image signal saved in the input memory.
[Procedure]
1. Select INPUT MEMORY in DISPLAY in the menu 2.
2. Select the input memory.
3. Press [ENTER] button to call the input memory.
•
If you don’t call it, the setting goes back to the last saving value.
•
It is unnecessary to change if the setting is not changed. Current input memory number is
called at first.
•
If input memory has not been saved, it displays “UNDEFINE”. In this case, the display
memory cannot be saved. Save the input memory first.
1.8.2. H.DISPLAY POS, V.DISPLAY POS
Used to adjust the position and expansion ratio on the multi-screen.
[Procedure]
1. Select DISPLAY in the menu 2.
2. Set the values of H.DISPLAY POS. and V. DISPLAY POS. The “n” of parameter n/m
indicates the panel position in the vertical and horizontal direction. The “m” indicates the total
number of screens in the directions.
For the detail setting in the case of daisy-chained multi-screen, see “1.9 Setting as daisy
chain connection” on page 50.
1.8.3. CROP
This adjustment is normally unnecessary since it will be automatically renewed when H./V.
DISPLAY POS. are changed.
Used to set the starting position of the actual display area from the effective input signal area by
manual. The adjustment is required in a specific case as displaying a contents in the partial area
of input signal.
•
H.POSITION
：
The horizontal starting position of the actual display area.
•
V.POSITION
：
The vertical starting position of the actual display area.
•
H.SIZE
：
The horizontal size of actual display area.
•
V.SIZE
：
The vertical size of actual display area.
[Procedure]
1. Select CROP in DISPLAY in the menu 2.
2. Adjust each item.
Note: It will be automatically renewed when H./V. DISPLAY POS. are changed.
