Mitsubishi Electric SRK100VNPZJX, Техническое руководство

Страница: 444 / 509

Error code
Remote controller:
Content
1 time flash Keeps flashing
Keeps flashing
– –
Indoor display
RUN light TIMER light
Green LED
Yellow LED
Red LED
Outdoor
control PCB
Outdoor
inverter PCB
E45
1. Applicable model
5. Troubleshooting
All models
Diagnosis Countermeasure
YES
NO
YES
Replace the outdoor control PCB
NO
YES
YES
NO
Is the
connection of connectors between
the inverter PCB and the outdoor
control PCB OK?
Are both
switches of JSW10,11
on the inverter PCB
set correctly?
Is LED
on the inverter PCB
flashing?
For 3-phase models
Is the
communication wire between the
inverter PCB and the outdoor control
PCB connected properly?
Does it become normal?
YES
NO
NO
NO
For single-phase models
Note(1) How to check
voltage at CN13
⇒
See E51
Note(2) Under anomalous
conditions, the
voltage becomes
less than DC14V
Is DC15V
detected between
②
and
③
on CNI3?
Is DC15V
detected after disconnecting
outdoor fan motor?
YES
YES
⑴
⑵
NO
Correct the connection.
Set JSW10, 11 correctly
⇒ See page 346 or 347.
No power is supplied to
inverter PCB.
Check the power supply
voltage and correct it
If not solved, find the
cause by checking
following points.
• Fan motor anomaly
Replace outdoor fan motor
Replace control PCB
if not solved, replace
inverter PCB as well
Connect the
communication wire
securely
Replace inverter PCB
OK
2. Error detection method
When the communication
between inverter PCB
and outdoor control PCB
is not established.
3. Condition of Error displayed
Same as above.
4. Presumable cause
• Defective inverter PCB
• Defective connector between
the outdoor control PCB and
inverter PCB
• Defective outdoor control
PCB
• Defective outdoor fan motor
Note:
Communication error between
inverter PCB and outdoor control PCB
- 443 -
'12 • PAC-T-174