Mitsubishi Electric SRK100VNPZJX, Техническое руководство

Страница: 503 / 509

-
502
-
'12 • PAC-T-174
DO NOT install the interface and wired remote controller at the
following places.
○
Places exposed to direct sunlight
○
Places near heating devices
○
High humidity places
○
Surfaces where are enough hot or cold to generate condensation
○
Places exposed to oil mist or steam directly
①
Mount the lower casing of the interface on a flat surface with wood
screws provided as standard accessory.
②
Mount the upper casing.
○
Uneven surface
①
Mount it on a wall or a pillar
with 2 of wood screws
②
Mount it to the electrical box
with 2 of M4 screws
(procured locally)
②
Mount the
upper casing
③
Mount the upper casing
Electrical box
(procured locally)
Connection cable
Wiring inlet
Wiring inlet
Installation check items
Mounting the interface with the mounting bracket
Mounting the interface directly on a wall
Recessing the interface in the wall
・
Install the interface within the range of the connection cable length
(approximately 1.3m) from the indoor unit.
・
Be sure not to extend the connection cable on site. If the connection
cable is extended, malfunction may occur.
・
Fix the interface on the wall, pillar or the like.
Cut out the punch-outs
for the connection cables
running into the casing
with cutter
①
Recess the electrical box (locally procured) and
connection cables in the wall.
②
Mount the lower casing of the interface to the
electrical box with M4 screws (locally procured).
③
Mount the upper casing.
①
Mount the mounting bracket to the interface with tapping
screws provided as standard accessory.
②
Mount the mounting bracket on wall or the like with wood
screws provided as standard accessory.
③
Mount the mounting bracket to a wall surface, etc.
using the wood screws provided.
□
Are the connection cables connected securely to the terminal blocks and connectors?
□
Are the thickness and length of the connection cables conformed with the standard?
Installation of the interface
①
Recess the electrical
box and connection cables
②
Mount the mounting
bracket on the interface
with 2 of tapping screws
③
Mount the bracket on
a wall or a pillar with
2 of wood screws