206
Using the Configurator
19.52.3 Call Control
The operator can call all the nodes that are correlated to the node’s telephone/page selector
by pressing the Call Control switch on the master telephone (QMT-5302N(V)).
In this example three-node system, the following correlations have been made:
•
Node 1 switch number 0 <--> Node 3 switch number 0
•
Node 1 switch number 1 <--> Node 2 switch number 0
1. Press the Call Control switch on node 1.
Nodes 1, 2, and 3 sound their buzzers and the green LEDs blink.
2. Press switch number 0 on node 3 to answer the call from node 1.
All nodes turn off their buzzers.
The green LEDs on node 1 and node 3 turn solid.
The green LED on node 2 blinks (the call from node 1 can still be answered).
3. Press switch number 0 on node 3 to disconnect the call from node 1.
4. Press the Deselect All switch on node 1 to disconnect all calls from this node.
19.52.4 Master telephones in the Configurator
This section describes how to set up master telephones on the three-node system described
in section 19.52.2 on page 205.
Add the audio controllers and master telephones
Add an audio controller, a master telephone, and a telephone/page selector to each node as
described in sections 19.24, 19.51.3 and 19.51.4. For each audio controller select the
Master
Handset
check box.
Assign the phone selector switches
1. Select the Telephone/Page Selector under node 1’s Main Display.
2. For switch number 0, double-click
<unassigned>
and select
Phone Sel
.
Figure 163 Make a switch a phone selector switch
3. For switch number 1, double-click
<unassigned>
and select
Phone Sel
.
4. Repeat steps 1 and 2 for nodes 2 and 3.
Correlate the phone selector switches across nodes
1. Select the Telephone/Page Selector under node 1’s Main Display.
2. Select the row for switch number 0, and then click
Insert
in the menu bar, then click
Add
Correlations
.
