Using the Configurator
163
Figure 121 AP base selection
When you add an AP detector, the default address is the lowest available address for AP
devices. The address has the prefix
S
. If there is an associated relay base or sounder base,
the base has the same address with a
B
prefix. For example, a Photo (AP) at address S100
has a sounder base at address B100.
Figure 122 Photo (AP) device with the address 100
19.15.1 Removing a Sounder Base from an AP Device
If AP devices are being used without sounder bases, you can remove the virtual device
sounder base that was automatically added with the AP device.
Remove a sounder base
1. Select the sounder base in the Configurator.
2. Press Delete on the keyboard.
3. Click
Yes
to confirm.
4. Repeat these steps for every sounder base that you want to delete.
Note:
Only AP devices that are branded as Mircom, Secutron, or System Sensor will
work properly with a FleX-Net™ system. Other brands of sensor will not work
consistently or at all.
Note:
If you remove a sounder base from an AP device, it cannot be restored. In order
to restore the sounder base, you must delete the whole device and add it again.
i
i