SNMP-SSL
32
Chapter 5 SNMP-SSL Management
The following menus allow the user to configure the SNMP-SSL control parameters. All
the menus are available for all users in the read-only mode, except for the administrator,
which has access in the read/write mode.
Date and Time
This menu allows you to set the SNMP-SSL card internal date and time.
There are three ways to set the Date and Time:
1. Synchronize with computer time
2. Synchronize with NTP server
3. Set the date and time manually
4.
Set Value:
Saves the settings.
Figure 5-1 Date and Time
SNMP-SSL Configuration
This menu allows the administrator to set the local network configuration parameters for
the SNMP-SSL card. The basic variables for SNMP management can also be set.
1.
SNMP-SSL IP Address:
The IP address of the SNMP-SSL card (e.g.
192.168.1.100). Note that changing the IP Address of the SNMP-SSL card does not
require rebooting.
2.
SNMP-SSL Gateway Address:
The IP address of the network gateway (e.g.
192.168.1.254).
3.
SNMP-SSL Subnet Mask.
The Subnet Mask for your network (e.g. 255.255.255.0).
4.
System Name:
SNMP Network Administrator string.
5.
System Contact:
SNMP Network Administrator string.
6.
System Location:
SNMP Network Administrator string.
7.
Last Battery Replacement Date:
The date when the UPS’s batteries were last
replaced. Only the Administrator should reset this value.
