SNMP-SSL
31
EMD Configuration
This menu allows you to configure all necessary parameters of an EMD and the Contact
Devices. The temperature, humidity and the contact devices values will be displayed on
the Comprehensive View page. See the SSL-EMD Users Manual and the Contact
Devices Quick Install for installation instruction.
1.
Sensor Name:
Configure the name of a sensor (or device) with up to 15 characters.
2.
Set Point:
The threshold of a sensor (Temperature or Humidity) will trigger an alarm,
whenever the measurement is over (high) or under (low) the set point. If the
checkbox is not filled, the threshold is disabled and the alarm will not be triggered.
3.
Calibration Offset:
If the measurement value of a sensor does not, for whatever
reason, comply with the actual environment, the 'Calibration Offset' setting can be
configured to adjust the final value of the sensor.
4.
Alarm Type:
If an alarm sensor (water leak, security, etc) is connected to the
SNMP-SSL card, the user can configure the alarm as 'Disabled', 'Normal Open', or
'Normal Close'. A 'Disabled' setting will mean the alarm is inactive.
5.
EMD Status:
The EMD can be configured as 'Disabled' or 'Auto'. The setup should
be configured as 'Disabled' if an EMD is not attached to the port. The EMD type will
be auto detected by the SNMP-SSL card if configured as 'Auto' and if the EMD is
plugged into the port.
6.
EMD Temperature over Threshold:
Shutdown occurs when EMD temperature
sensor detects a high or low temperature when, the UPS Shutdown is configured.
7.
EMD Alarm-1:
Shutdown occurs when alarm-1 sensor detects an active alarm when,
the UPS Shutdown is configured.
8.
EMD Alarm-2:
Shutdown occurs when alarm-2 sensor detects an active alarm when,
the UPS Shutdown is configured.
9.
Set Value:
Saves the settings.
Figure 4-8 EMD Configuration screen
