Mindray BeneView T8, Руководство по эксплуатации

Страница: 275 / 290

Alarm Messages
D-3
D.2 Technical Alarm Messages
Measure
ment
Alarm message A B Cause and solution
XX SelfTest Err √ ×
XX Init Err √ ×
XX Init Err N
√ ×
N is within 1 to 8
XX Comm Err √ ×
XX Comm Stop × ×
An error occurred to the XX module, or there is
a problem with the communications between the
module and the monitor. Re-plug the module
and restart the monitor, or plug the module into
another monitor.
XX Limit Err × × XX parameter limit is accidentally changed.
Contact your service personnel.
XX
XX Overrange × × The measured XX value is not within the
specified range for XX measurement. Contact
your service personnel.
MPM 12V Err
× ×
MPM
MPM 5V Err
× ×
An error occurred to the power supply part of
the MPM module. Contact your service
personnel.
ECG Lead Off × √
ECG YY Lead Off ECG × √
Note: YY represents the leadwires,
V (V1, V2, V3, V4, V5, V6,), LL,
LA, RA, as per AHA standard, or C
(C1, C2, C3, C4, C5, C6), F, L and R
as per IEC standard.
The electrode has become detached from the
patient or the lead wire has become
disconnected from the adapter cable. Check the
connection of the electrodes and leadwires.
ECG Noisy √ × The ECG signal is noisy. Check for any possible
sources of signal noise form the area around the
cable and electrode, and check the patient for
great motion.
ECG
ECG Signal Invalid × √ The ECG signal is saturated. Check the
leadwires.
Resp Resp Disturbed
√ ×
The respiration circuit is disturbed. Restart the
monitor.
Temp Cal. Err
× ×
A calibration failed. Restart the monitor.
T1 Sensor Off
√ ×
Temp
T2 Sensor Off √ ×
The Temp sensor has become detached from the
patient or the module. Check the sensor
connections.
SpO
2
SpO2 Sensor Off √ × The SpO
2
sensor has become detached from the