Mindray BeneHeart D3, Руководство оператора

Страница: 169 / 186

D-5
Measurement Alarm Message L I Cause and solution
Monitor Module Selftest Err H C An error occurred during MPM module power-on self test.
Contact your service personnel.
Monitor Module Reset Err H C MPM module reset abnormally. In this case, the MPM module
restores to default configuration. You can ignore this
problem.
Monitoring
module
Monitor Module Voltage Err L C The voltage of MPM module is abnormal. Contact your service
personnel.
Recorder Init Err L A Restart the equipment.
Recordhead Overheated L A The recorder has been working for a prolonged time. Clear
the recording tasks and resume the recording till the
recorder’s print head cools down.
Recorder
Recorder Overcurrent L A Re-load the recorder paper.
Others Config Err L A Check if the configuration is correct, or restore the factory
configuration.
Pads cable Off H C Check that pads cable is properly connected.
Pads Off H C Check that pads are properly connected.
ECG Lead Off H C Check that ECG leadwires are properly connected.
Pacer
Pacer Stopped Abnormally H C Check paddles. Check that pads well contact with patient’s
skin. Make sure pads are properly applied, and then start
pacing again.
Note: In the “L” column “S” refers to special technological alarm. The special technological alarms cannot be paused or
silenced, and the alarm volume is unchangeable. These alarms stop only when the alarm condition is eliminated.