Mindray BeneHeart D3, Руководство оператора

Страница: 137 / 186

22-9
22.3.8 Pacing Test
Test tools: defibrillator/pacer analyzer
1. Run the equipment on fully charged battery. Move the Mode Select knob to Pacer. Select Fixed mode..
2. Connect the pads cable to the equipment and properly place the pads on the defibrillator/pacer analyzer.
3. Set the analyzer to Pacing Measurement mode. Use test load of 50Ω.
4. On the equipment, set [ Pacer rate ] to [ 70ppm ] and [ Pacer Output ] to [ 30mA ].
5. Press the [ Start Pacing ] soft key. Verify that the pacer rate measured by the analyzer is 70 ppm±1ppm and the
pacer output measured is 30 mA±5mA.
6. Press the “ Stop Pacing ” soft key, and then set [ Pacer rate ] to [ 170ppm ] and [ Pacer Output ] to [ 200mA ].
7. Press the [ Start Pacing ] soft key. Verify that the pacer rate measured by the analyzer is 170 ppm±2ppm, and the
measured current is 200 mA±10mA.
22.3.9 Peforming Testing in Installation Mode
You can view software version and format storage card.by accessing the Installation Mode.
22.3.9.1 Password for Installation Mode
Accessing installation mode is password protected. The required password is set to 888888 before the equipment leaves
the factory.
22.3.9.2 Accessing Installation Mode
You can access Installation Mode while operating in the Monitor, Manual Defib or Pacer mode. Patient monitoring and
therapy automatically end when you enter Installation Mode.
To enter Installation Mode, press the Main Menu button on the front panel, and then select [ Others >> ] [
→
Maintenance
>> ] [
→
Installation Mode >> ] enter the required password. The
→
Installation Mode Main menu pops up as shown
below.