MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 72 / 144

3-12
Chapter 3 Setup
6
Press the key.
7
Press to select “BELT FEED
SPEED”, and press the key.
• When the setting of “BELT WASH” is “OFF”,
“BELT FEED SPEED” can not be indicated.
8
Press to select set value, and
press the key.
• Set value: NORMAL, LOW
9
Press the key several times to
end the setting.
Setting Maintenance Notification
Time (COUNTER LIMIT)
Maintenance notification times (for adhesive replacement
and absorb roller cleaning) can be set based on print
length (in meters).
1
Press (MENU) in LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press
(<<)
.
4
Press to select “COUNTER
LIMIT”, and press the key.
5
Press and press to
select “Adhesive” or “Absorb Roller”.
6
Press and press to set
print length.
• Adhesive settings: OFF, 1 to 30000m
(10m intervals)
• Absorb roller settings: OFF, 1 to 30000m
(10m intervals)
7
Press the key.
8
Press the key several times to
end the setting.
• When doing an overprint or the feeding belt is
badly dirty due to a bleed-through, set it in “LOW”.
If performing a jog feeding in “NORMAL”, the
feeding belt may not be washed enough.
• Setting maintenance notification times allows you
to carry out work without being concerned with
maintenance times since the machine will notify
you before maintenance needs to be performed.
• No maintenance notification will occur if no setting
is provided.
• The unit of input can be changed as 10m
→
100m
→
1000m
→
10000m by every pushing the
key.