MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 23 / 144

Chapter 1 Before Use
1-9
1
2
2
2
5
6

Removing USB memory
If a USB memory module is inserted in the personal
computer to which a Tx300P-B machine is connected,
click “Stop” in the “Safely Remove Hardware” window
by following the instructions given there first and then
remove the module.
Leaving a USB memory module inserted can cause
[ERROR 10 COMMAND ERROR].
Copy the data onto the hard disk before outputting it
for printing.
Connecting the LAN cable
When connecting LAN cable, be sure to follow the note
below:
Printing Via a Network
If printing via a network, you need to configure your
network with the following environment.
If you configure it with an inappropriate environment, it
could cause printing to stop.
• Use LAN cables that are category 6 or higher.
• Use a switching hub and PC that support 1000BASE-T.
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
• Check that “1000Mbps” is displayed for the LAN status
item.
(2)
Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
• Surely insert LAN cable until clicking noise
sounds.
• Do not plug in or unplug any cable during data
transferring.
• Set the PC sending the print data and the printer
to the same network.
• You cannot connect via a router.

If connecting directly to the printer
• If “100Mbps”, “10Mbps”, or “No connect” is
displayed, you cannot print using the LAN.
• If “100Mbps” or “10Mbps” is displayed, you can
use event mail ( Chapter3 “Setting event mail
function”).
Color State Condition
Green
Lighting Connected with 1000BASE-T
OFF Connected without 1000BASE-T
Yellow
Lighting Link-up
Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.
Switching hub

If connecting via a switching hub
INFORMATION
LAN Status 1000Mbps