MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 29 / 144

1-15
1
2
2
2
5
6
Chapter 1 Before Use
Limited media
With the following media, correction from the plotter is difficult.
When using any of the following media, perform test printing to determine whether it can be used or not.
• High stretch fabric (Stretch materials, vertically extendable knit,etc.)
• Materials which become largely extendable when getting wet by printing.
• Materials with large width variations.
• Materials which present partial wrinkles of slacks when being spread on a flat surface or materials which are totally curved.
• Materials with large take-up shift at the ends of media when rolled.
• Roll media with a paper tube whose strength is insufficient and which bends when attached to a feeding unit.
Fabric conditions which enable to print
• Even when using media other than described above, be sure to print by optional test data. After checking the printing
result, judge whether it can be used or not.
Items Condition Remarks
Width variation less than

5mm / one side edge
Curve when expanded One-direction curve not allowed
Slack height when expanded
on a flat surface
2mm or less
Displacement of roll edge

15mm,
Cloth (width of 500mm and less) is

2mm.
Inner diameter of roll 1 to 1.5-inchs, 2 to 3-inchs
Fabric core strength Roll bend of 5mm or less when set.
Fixation with fabric core Fix with the tape three point or more or weak adhesion.
Roll outer diameter

250

mm or less
Roll weight
1 to 1.5-inch, 34kg or less
2 to 3-inch, 40kg or less
Print side Not specified
Fabric wrinkle Not allowed