MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 66 / 144

3-6
Chapter 3 Setup
7
Press the key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the
operation in Step 7 to make correction.
8
Press the key several times to
end the setting.
Correcting Media-feeding during Printing
A media-feeding rate can be corrected even in the remote
mode or when image data is printed.
1
Press
(ADJUST)
in the
Remote.
2
Press to enter a corrected
feeding rate.
• Corrected feeding rate: -9999 to 9999
• The value entered here is reflected in the
corrected feeding rate soon.
3
Press the key twice .
• The changed value is registered.
• When you press the [ENTER] key instead of the
[END] key, the value entered here will be valid
temporarily. (When you perform media detection
again or turn the power OFF, the correction value
is cleared.)
If the Positions of Dots Shift...
When the condition for printing (media thickness/ink type/
etc.) has been changed, perform the following operation
to correct the ink drop position for bidirectional (Bi)
printing and obtain the proper printing result.
Example of a Printed Pattern
1
Set a media on the machine. ( P.2-4)
• In order to print a pattern, a media that is 500 mm
wide at least is necessary.
2
Press (MENU) in LOCAL.
3
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
4
Press to select “DROP.POS
correct”, and press the key.
5
Press the key.
• Start the pattern printing.
• Multiple test patterns are printed. (The printed
patterns are called Pattern 1, Pattern 2, Pattern
3... in the order of printing.)
6
Press to enter a correction value
of Pattern 1, and press the key.
• Corrected feeding rate: -40 to 40
• Check the test patterns. The position where an
outward feeding line and a return feeding line
become one straight line is the correction value.
• When the correction value in not between -40 and
40, adjust the height of the printing heads and
then perform the operations in Step 2 and later.
7
In the same way as in Step 4, enter a
correction value of Pattern 2 and later, and
press the
key.
8
Press the key several times to
end the setting.
The dots at the fourth position counted
from the zero position in the positive
direction form a straight line.
In this case, the dot position correction
value is 4.0.
Output
direction