MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 26 / 144

Chapter 1 Before Use
1-12
Replacing the 2L Ink Pack
Perform as follows when [INK END] or [INK NEAR END]
is displayed on the display.

When [INK END] is displayed
1
Push the lever of the base down, and
remove the 2L eco-case.
2
Remove the IC chip.
3
Open the 2L eco-case, then replace the 2L
ink pack.
• Keep the IC chip removed in the step 2 with used
2L ink packs.
(Not to mix with an IC chip of a new ink pack)
4
Mount the IC chip supplied with the
replacement 2L ink pack.

When [INK NEAR END] is displayed
There is a little of ink left. It is recommended to replace
the ink pack soon since ink may become empty in
printing while printing is continuously enabled.
• When exchanging 2L ink pack, be sure to wear
goggles and gloves. Ink may spatter and get in
your eyes accidentally.
• Although approximately 10 cc of ink remains in
the ink pack after use, the pack is filled so that the
actual amount used is two liters.
• When replacing the 2L ink pack, replace the male
connector absorbent (attachment) periodically to
prevent the stain in the base.
• Replace the absorbent
every five to ten times
of the 2L ink pack
replacement.
• When replacing the
absorbent, be sure to
wear the attached
goggles and gloves.
IC chip
• Be careful not to touch the metal part of the IC
chip. There is the danger of damaging IC chip
because of static electricity being generated.
• Request an industrial waste disposal company for
disposal of used ink packs.
• If removing an ink pack before it ends, follow the
procedures below.
Otherwise, you cannot accurately grasp the
remaining amount of ink.
(1) Remove an ink pack from an eco-case.
(2) Wipe ink adhering to inside of the connector
part of the 2L ink pack with a cotton swab
etc.
(3) Remove the IC chip, and keep it with the ink
pack.
(4) If you use the ink pack again, set the pack,
and mount the IC chip kept with the pack.
• During [INK NEAR END] is displayed, Auto
cleaning does not operate.( P.3-10)
IC chip