MIMAKI SWJ-320EA, Руководство по эксплуатации

Страница: 107 / 116

5-13
Chapter 5 Troubleshooting
1
2
2
2
5
ERROR 425
Take-UP WRONG An error occurred in the take-up status of the
take-up unit.
• Check if the media setting is set to ROLL
when the take-up device is not used.
• Check if the taking-up direction switch and the
taking-up manual switch are set correctly.
• Check that the media can be taken up to the
take-up unit.
• Check if the media take-up paper core is run-
ning without load.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time when
the error occurred.
ERROR 426
Feeding WRONG An error occurred in the take-up status of the
feeding unit.
• Check if the media setting is set to ROLL
when the feeding device is not used.
• Check if the taking-up direction switch and the
feeding manual switch are set correctly.
• Check that the media can be taken up to the
feeding unit.
• Check if the media feeding paper core is run-
ning without load.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time when
the error occurred.
ERROR 427
Take-UP CoverOPEN It was detected that the media take-up device's
cover was open.
• Close the take-up device's cover.
ERROR 428
Feeding CoverOPEN It was detected that the media feeding device's
cover was open.
• Close the feeding device's cover.
ERROR 429
Take-UP LimitDETECT
The take-up limit was detected.
• Check if the media can be fed correctly in the
jog operation.
• Lower the position of the tension bar on the
take-up side by using the manual switch.
ERROR 42a
Feeding LimitDETECT
The feeding limit was detected.
• Check if the media can be fed correctly in the
jog operation.
• Lower the position of the tension bar on the
feeding side by using the manual switch.
ERROR 432
Take-UP Connect
Take-up device connection destination error
• Turn off the power on the machine and turn it
on after a while.
• When displaying again, contact your local dis-
tributor, our sales office, or service center.
ERROR 433
Feeding Connect
Feeding device connection destination error
ERROR 436
Take-UP Fuse Err
Take-up fuse blown
ERROR 437
Feeding Fuse Err
Feeding fuse blown
ERROR 442
Take-UP Voltage An abnormality occurred in the take-up unit volt-
age.
ERROR 443
Feeding Voltage An abnormality occurred in the feeding unit volt-
age.
ERROR 44d
STATION POS ERROR
Abnormal station position
ERROR 46b
TAKE-UP ENC WRONG
An error occurred in the take-up device.
ERROR 46c
FEEDING ENC WRONG
An error occurred in the feeding device.
• Turn off the power on the machine and turn it
on after a while.
• When displaying again, contact your local dis-
tributor, our sales office, or service center.
ERROR 50a
Y ORIGIN
Y-origin could not be detected.
Message Cause Solution