MIMAKI SWJ-320EA, Руководство по эксплуатации

Страница: 36 / 116

2-10
3
Move the media press to outside.
4
Move the roll holder R on the back of this
machine.
• Loosen the roll holder fixing screw and then move
it.
• Move the roll holder to such a position that the
media will be set in the center of this machine.
5
Tighten the fixing screw of roll holder R.
6
Set the roll tables as shown in the figure
and temporarily place the media on top of
the tables.
• Keep a proper space between the tables to
stabilize the media.
7
Insert the paper core into the roll holder R.
8
Loosen the screw of the roll holder C then
insert the holder into the core of the roll
media.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
9
Remove the roll tables
10
Raise the clamp lever in the rear side of
this machine.
• The roll holder guide shaft has a mark indicating
the center position. Refer to this mark when
setting.
• If it is difficult to directly set the media in the roll
holders, temporarily set on the roll tables and then
set the roll holders to make setting easier.
Media Press
Roll holder fixing screw
Roll honder R
Roll table
Roll stopper
Clamp lever