MIMAKI SWJ-320EA, Руководство по эксплуатации

Страница: 103 / 116

5-9
Chapter 5 Troubleshooting
1
2
2
2
5
TAKE-UP TENSION-BAR
The media set check at the start of printing
detected an abnormality of the take-up tension
bar.
• Check the media set condition and remove
any cause of the problem.
• Check that the taking-up direction switch is set
correctly. ( P.2-6)
Take-UP Voltage
An abnormality occurred in the take-up unit volt-
age.
• Turn off the power on the machine and turn it
on after a while ( P.2-3).
• When displaying again, contact your local dis-
tributor, our sales office, or service center.
Feeding CoverOPEN
It was detected that the media feeding device's
cover was open.
• Check the cover of the feeding unit.
Even if you close the cover, if the same
message is displayed, contact a
distributor in your district, our office or our
call center.
Feeding WRONG
An abnormality occurred in the feeding status of
the media feeding machine.
• Check if the media setting is set to ROLL
when the feeding device is not used.
• Check if the taking-up direction switch and the
feeding manual switch are set correctly.
• Check that the media is set on the media
feeding machine correctly.
• Check if the media feeding paper core is run-
ning without load.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time when
the error occurred.
Feeding LimitDETECT
The control limit sensor of the media feeding
machine was detected.
• Check if the media can be fed correctly in the
jog operation.
• Lower the position of the tension bar at the
feeding side.
• When displaying again, contact your local dis-
tributor, our sales office, or service center.
FEEDING ENC WRONG An abnormality occurred in the feeding encoder. • Turn off the power on the machine and turn it
on after a while ( P.2-3).
When displaying again, contact your local dis-
tributor, our sales office, or service center.
Feeding Connect The feeding unit is not correctly connected.
Feeding Fuse Err The feeding fuse is blown.
FEEDING TENSION-BAR
The media set check at the start of printing
detected an abnormality of the feeding tension
bar.
• Check the media set condition and remove
any cause of the problem.
• Check that the feeding direction switch is set
correctly. ( P.2-6)
Feeding Voltage
An abnormality occurred in the feeding unit volt-
age.
• Turn off the power on the machine and turn it
on after a while ( P.2-3).
When displaying again, contact your local dis-
tributor, our sales office, or service center.
REPLACE WIPER
Time to replace the wiper on the capping station
(The number of times of wiping has reached a
specified value.)
• Perform [Replace Wiper] in [Station], and
replace the wiper. ( P.4-19)
DATA REMAIN Data was received.
• Execute the data clear. ( P.2-22)
Restart if the error message remains after the
execution of the data clear.
MACHINE TEMP./H ***°C The machine is hot.
• Use cooling equipment to lower the room tem-
perature to a specified range.
• Wait until the machine cools down.
• When displaying again, contact your local dis-
tributor, our sales office, or service center.
MACHINE TEMP./L ***°C The machine is cold.
• Use a heating system to raise the room tem-
perature to a specified range.
• Wait until the machine warms up.
• When displaying again, contact your local dis-
tributor, our sales office, or service center.
Message Cause Solution