MIMAKI CF3-1610, Руководство по эксплуатации

Страница: 92 / 166

3-2
Assigning Pen Numbers
This section describes how to assign pen numbers in the data to tools on the unit.
For this unit, up to six pens can be assigned to each tool.
This example describes how to make the following settings.
Pen 1 (pen number in drawing data) : Set to PEN.
Pen 2 (pen number in cutting data) : Set to
θ
CUTTER 1 (Tangential Cutter 1).
The following settings allow simultaneous drawing and cutting of Pen 1 and Pen 2 data.
1
Display the third page of the local menu.
• Press several times.
2
Press .
[MODE SET] is selected.
3
Display the fifth page of the MODE SET
menu.
• Press several times.
4
Press .
[PEN ASSIGN] is selected.
5
Press to change HEAD from B to A.
• Set values: A, B, C
6
Press and select TOOL to
[PEN].
• The set values differ according to the mounted tools.
7
Press to display the PEN 2 setup
menu.
8
Press to change HEAD from A to B.
• Set values: A, B, C
[ LOCA L ] 3 / 5
I NT ERF ACE - - - >
MODE SE T - - - >
SE L F T EST - - - >
<MODE SET > 1 / 7
Z S TROKE 7mm>
MUL T I - PASS - - - >
VACUUM - - - >
<MODE SET > 5 / 7
PEN ASS I GN - - - >
DRAW L V L NORMA L >
UN I T
mm>
< PEN ASS I GN> 1 / 6
PEN 1
HEAD
B >
TOOL
θ
CUT T ER1 >
< PEN ASS I GN> 1 / 6
PEN 1
HEAD
A >
TOOL
θ
CUT T ER1 >
< PEN ASS I GN> 1 / 6
PEN 1
HEAD
A >
TOOL PEN>
< PEN ASS I GN> 2 / 6
PEN 2
HEAD
A >
TOOL R . CUT T ER1 >
< PEN ASS I GN> 2 / 6
PEN 2
HEAD
B >
TOOL R . CUT T ER1 >