MIMAKI CF3-1610, Руководство по эксплуатации

Страница: 136 / 166

6-2
Now What Do I Do?
Problem Solution
Inadequate cutting
• When the cutter descends, cutting is incomplete,
although the blade protrudes by more than the
workpiece thickness.
The workpiece can be reliably cut by increasing the
pressure when the cutter descends.
• Set or increase the pressure offset value that is added
to the press value.
P.2-12 "Setting the Cutting Conditions"
Cutting incomplete at the start or end point
• Cutting is incomplete at the positions where the cutter
descends or ascends.
Increase the start offset setting to move forward the
position where the cutter descends.
P.2-12 "Setting the Cutting Conditions"
Increase the end offset setting to move backward the
position where the cutter ascends.
P.2-12 "Setting the Cutting Conditions"
Circle start and end points do not match
• A circle start and end points can be displaced due to the
workpiece thickness and hardness.
Use circle
θ
correction to correct for the displacement.
Grid lines torn along flutes of corrugate cardboard.
• Tearing can occur if the press value in the cutting
conditions is too high when grid cutting along the flutes
of corrugated cardboard.
(1) Align the corrugated cardboard flutes in the Y-axis
direction.
(2) Set the press value in the cutting conditions.
(
P.2-12)
Workpiece lifts up (Model M)
• A workpiece fastened by vacuum adhesion can be lifted
up if the workpiece is small or the dust-collection force
is too high.
• Use a workpiece no smaller than 50 mm dia.
• Open the dust-collector adjusting window and adjust the
dust-collection force. ( P.6-13)
• Ensure that the dust-collector brush does not contact
the workpiece.