MIMAKI CF3-1610, Руководство по эксплуатации

Страница: 79 / 166

2-23
Making a Test Cut
2
Bas
ic Operations
Checking the Tool Status
Make a test cut using the tool selected by the Tool Select function. This section describes the check items for
each tool.
Pen (Model TF2 or Model R1)
Tangential Cutter (Model TF2 or Model R1)
Check Point Cause Remedy See page
Point A contact points do not
match Pen incorrectly mounted. Fully tighten the holder screw.
P.1-19
Lines broken or faint Out of ink Replace the pen with a new one. P.1-19
Press value low Increase the “PRESSURE” in the
cutting conditions.
P.2-12
Speed is too high, causing the
pen to lift. Decrease the “SPEED” in the cutting
conditions.
P.2-12
Check Point Cause Remedy See page
Point A contact points do not
match “E OFFSET” value too low in
cutting conditions. Increase the “E OFFSET”.
P.2-12
Blade is mounted eccentrically Conduct Adjust Eccentricity in tool
adjustments.
P.6-6
Lines displaced at Point A Abnormal angle
θ
of tangential
cutter
Conduct Adjust
θ
in tool adjustments.
P.6-8
Cutting incomplete Press value low Increase the “PRESSURE” in the
cutting conditions.
P.2-12
Cutting incomplete at corners The “F OFFSET” and “E
OFFSET” values in the cutting
conditions are too low.
Increase the “F OFFSET” and “E
OFFSET”.
P.2-12
D and D' have different
dimensions Blade is mounted eccentrically Conduct Adjust Eccentricity in tool
adjustments.
P.6-6
Too many cuts at Point C “F OFFSET” value is too large. Decrease the “F OFFSET” in the
cutting conditions.
P.2-12
Blade is mounted eccentrically Conduct Adjust Eccentricity in tool
adjustments.
P.6-6
Point A
Point B
Point C Point D Point D'
Test cut pattern drawn by Model TF2 or Model R1