Installation and Settings
UG0617 User Guide Revision 4.0
6
3
Installation and Settings
This section provides information about the software and hardware settings for the RTG4 Development
Kit.
3.1
Software Installation
Download and install the latest Microsemi Libero
®
System-on-Chip (SoC) software from the Microsemi
website and obtain a Platinum license, which is not included in the RTG4 Development Kit. Libero v11.4
or later installer has FlashPro5 drivers. For instructions on how to install the Libero software and
SoftConsole, see
Libero Software Installation and Licensing Guide
.
For instructions on how to download and install Microsemi DirectCores, SGCores, and driver firmware
cores, see
Installing IP Cores and Drivers User Guide
. In order to design with Microsemi FPGAs and
SoC, these IP cores must be installed on the PC where Libero SoC is installed while designing with
Microsemi FPGAs and SoCs.
3.2
Hardware Settings
This section provides information about default jumper settings, switches, LEDs, and DIP switches for
the RTG4 Development Kit.
3.2.1
Default Jumpers Settings
Connect the jumpers with the default settings specified in the following table to evaluate the pre-
programmed demo design.
Table 3 •
Jumper Settings
Jumper
Description
Pin
Default Settings
Power Supply
J16
Jumper to select the RTG4 core
voltage VDD_REG to 1.2 V
Pin 1-2 for 1.0 V core voltage. Core
supply 1.0 V operation is not supported.
Open
Pin 2-3 for 1.2 V core voltage.
Closed
J19
Jumper to select the voltage levels
for MSIO-FMC connector
(VCCIO_HPC1_VADJ) to 3.3 V, 2.5
V, 1.8 V, 1.5 V, or 1.2 V
Pin 1-2 for 3.3 V.
Closed
Pin 3-4 for 2.5 V.
Open
Pin 5-6 for 1.8 V.
Open
Pin 7-8 for 1.5 V.
Open
Pin 9-10 for 1.2 V.
Open
J11
Jumper to select the voltage levels
for MSIOD-FMC connector
(VCCIO_HPC2_VADJ) to 2.5 V or
1.8 V or 1.5 V or 1.2 V
Pin 1-2 for 2.5 V.
Closed
Pin 3-4 for 1.8 V.
Open
Pin 5-6 for 1.5 V.
Open
Pin 7-8 for 1.2 V.
Open
J26
Jumper to short
VCCIO_HPC1_VIO_B_M2C_FMC
supply to 2P5
Two-pin header.
Closed
J21
Jumper to short
VCCIO_HPC2_VIO_B_M2C_FMC
supply to VCCIO_HPC2_VADJ
Two-pin header.
Closed
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from