MHG Heating ProCon HT 150, Руководство пользователя

Страница: 54 / 76

7. Technical documentation
ProCon HT 150 / HT 225
7.4.1 Display mode and programming AGU 2.361
•
Arriving at the display mode
To arrive at the display mode press and hold (> 3 sec) the display
mode button (8) . (Display (12): A...). Continue to hold down the
button to reach the different display levels b, C, d, P as well as A
once again. Release the button at the desired display level (A, b,
C, d or P).
•
Selection and display of individual values or
parameters
By subsequently pressing the display mode button (8) you are
alternating between the different values / parameters (0... max.
7) of the different display levels (A,
b, C, d and P). The current value will appear approx. 2 sec. after
selecting the respective parameter.
•
Changing parameters (only P0...P6)
Follow the procedure below to arrive at the different parameter
values:
Basic processes:
P
←
(+)
or (Enter)
Increase value
(+):
Press display mode
(8) briefly several
times(< 1 sec)
Reduce value
(-):
Press chimney sweep
button
(9) briefly
several times(< 3
seconds)
Store value
(Enter): Press and hold display
mode button (8) > 3
seconds
←
(-)
Ignore value
(Esc) Wait(For time see
parameter configuration
MMI)
To confirm, P0...P6 and the newly set value will appear in
succession on display (12). The newly set value will not be
valid until after it has been stored.
14
15
16
17
7
13
8
P
9
12
11
74 94z08 /0 801
10
Fig. 30: AGU2.361...
1. Use the display mode button (8) to select display level P
(Press and hold display mode button (8)).
2. Use the display mode button (8) to select the desired
parameter (Press display mode button (8) briefly).
3. Set value.
You can only make changes with the parameters (P0...P6) and
in order to do that, you must wait for the value of the parameter
to flash on display (12).
54