MGG Gizmow T130, Руководство оператора

Страница: 21 / 96

Lawn Tractor Rear Discharge
21
Your tractor is equipped with an operator presence sensing
switch. When engine is running, any attempt by the operator
WROHDYHWKHVHDWZLWKRXW´UVWVHWWLQJWKHSDUNLQJEUDNHZLOO
shut off the engine.
1. First, reduce the machine’s speed by reducing the
engine’s r.p.m.
7KHQFRPSOHWHO\SXVKWKHFOXWFKEUDNHSHGDOIRUZDUGWR
stop the unit. Keep your foot on the pedal.
3. Move the blade rotation control to the DISENGAGE
position.
4. Move the shift lever to the NEUTRAL position.
3XVKWKHSDUNLQJEUDNHEXWWRQDQGUHOHDVHSUHVVXUH
IURPWKHFOXWFKEUDNHSHGDO
6. Move the throttle control to the SLOW position.
7RVWRSWKHHQJLQHWXUQWKHLJQLWLRQNH\WRWKH2))
SRVLWLRQ5HPRYHWKHNH\
1. Start the engine.
2. Move the lift lever to a height of cut position.
3. Move the throttle control to the SLOW position.
4. Move the blade rotation control to the ENGAGE
position.
3XVKWKHFOXWFKEUDNHSHGDOFRPSOHWHO\IRUZDUG
6. Move the shift lever to one of the speed settings.
NOTE: When you mow in heavy grass or mow with a
bagger, put the shift lever in the slowest speed.
6ORZO\UHOHDVHWKHFOXWFKEUDNHSHGDO
8. Move the throttle control to the FAST position. If you
need to go faster or slower, needs not to stop the
unit can move the shift lever to another speed setting.
0DNHVXUHWKHOHYHORIFXWLVVWLOOFRUUHFW$IWHU\RX
PRZDVKRUWGLVWDQFHORRNDWWKHDUHDWKDWZDVFXW
If the mower housing does not cut level, see the
instructions on “How To Level The Mower Housing”
in the Maintenance section.
IMPORTANT: Leaving the ignition switch in
any position other than “OFF” will cause the
battery to be discharged (Dead)
NOTE: Under certain conditions when the lawn tractor is
standing idle with the engine running, hot engine exhaust
gases may cause “browning” of grass. To eliminate this
possibility, always stop engine when stopping tractor on
grass areas.
NOTE: You need to completely push down the
FOXWFKEUDNHSHGDOLQRUGHUWREUDNH
NOTE: If you fail to move the throttle control between half
and full speed (fast) position, before stopping may cause
HQJLQHWRªEDFN´UH«7KHUHIRUHLWLVLPSRUWDQWWR
‡7XUQLJQLWLRQNH\WRª2))«SRVLWLRQDQGUHPRYHNH\
$OZD\VUHPRYHNH\ZKHQOHDYLQJWUDFWRUWRSUHYHQW
unauthorized use.
‡1HYHUXVHFKRNHWRVWRSHQJLQH
IMPORTANT: To prevent damage to the belt
of the drive conversion unit or the wear and
tear of the brake system it is important to
transfer the gas control lever to the position
“MIN” while braking.
WARNING: Always stop tractor completely,
as described above, before leaving the
operator's position; to empty grass catcher
or conduct any check and adjustments.
WARNING: 7KHGHµHFWRULVDVDIHW\GHYLFH
'RQRWUHPRYHWKHGHµHFWRU7KHGHµHFWRU
forces the discharged material toward the
JURXQG$OZD\VNHHSWKHGHµHFWRULQWKH
GRZQSRVLWLRQ,IWKHGHµHFWRULVGDPDJHG
UHSODFHWKHGHµHFWRUZLWKDQRULJLQDO
equipment part from an authorized service
center.
IMPORTANT: In high or thick grass, cut
WKHJUDVVLQWKHKLJKHVWSRVLWLRQ´UVWDQG
then lower the mower housing to a lower
position.
WARNING: For better control of the unit,
always select a safe speed.
1. Before you ride up or down a hill, move the shift lever
to the slowest speed.
2. Do not stop or change speed settings on a hill. If you
PXVWVWRSTXLFNO\SXVKWKHFOXWFKEUDNHSHGDO
IRUZDUGDQGVHWWKHSDUNLQJEUDNH
7RVWDUWDJDLQPDNHVXUHWKHVKLIWOHYHULVLQWKH
slowest speed. Move the throttle control to the SLOW
position. Slowly release the pedal.
4. If you must stop or start on a hill, always have enough
VSDFHIRUWKHXQLWWRUROOZKHQ\RXUHOHDVHWKHEUDNH
and engage the clutch.
5. Be very careful when you change directions on a hill.
When on a slope or in a turn on a hill, move the
throttle control to the SLOW position to help prevent
an accident.
WARNING: Do not ride up or down slopes
that are too steep to back straight up.
Never ride the unit across a slope.
How to stop the unit
How to operate with the mower housing
How to operate the unit on hills