Description
Ref. No.
Cross brace STB ....................
29-406-70
Flange screw 18 ....................
29-401-10
Fixing screw 35/DW15 ..........
29-401-20
Twin channel 80/22...............
29-406-35
Fig. 38.1
STB 450 with horizontal Mammut formwork;
attachment of the STB to the multi-function
profile with flange screw 18
Fig. 38.2
STB 450 with vertical Mammut formwork; at-
tachment of the STB to the multi-function profile
using flange screw 18
Fig. 38.3
STB 450 with horizontal Mammut form-
work; attachment of the STB cross brace
to the multi-function profile using flange
screw 18 and of the STB through the tie
hole using fixing screw 35
Inside corner with cross brace STB and STB 450
There are various options avail-
able when using the cross brace
STB:
Figures 38.1 to 38.3 show the
use of the cross brace in conjunc-
tion with Mammut formwork.
The Mammut panels can be used
horizontally (Figures 38.1 and
38.3) or vertically (Fig. 38.2).
If the Mammut panel is used
horizontally, it is also possible to
attach the STB 450 either to the
multi-function profile with the
flange screw 18 (Fig. 38.1) or
using the tie hole with the fixing
screw 35. If the Mammut panel
is used vertically, the STB can be
attached to the multi-function
profile with the flange screw 18
(Fig. 38.2).
Due to their greater stiffness,
we recommend using large-size
panels in the lower area.
Due to the size of the STB 450,
it is always necessary to install a
vertical panel next to the inside
corner to avoid interference with
the support frames.
Attention
Æ
Refer the separate STB load
charts for the permissible loads
as a function of pouring height
and fresh-concrete pressure.
2.955 m
2.965 m
2.75 m
Attention
The distance between the inside corner
and the attachment of the STB 450 to the
Mammut formwork should not be greater
than 2.97 m!
STB-38
Technical Instruction Manual / Status November 2019
STB
Support frame
