metrotek Bercut-ET, Руководство по эксплуатации

Страница: 48 / 116

48 Analysis. Typical tasks and solutions
Figure 5.44. Src+Dst swapping mode
5.9.2 Configuring L3 Loopback
Figure 5.45. Layer 3 parameters
•
Replace IP — select the mode of IP addresses swapping:
– Off — IP address swapping is disabled;
– Source — swap Source IP address , see fig. 5.46;
– Destination — swap Destination IP address , see fig. 5.47;
– Src+Dst — swap both Source IP address and Destination IP
address , see fig. 5.48.
• Source — specify IP address that will substitute Source IP Address of
an Ethernet frame.
• Destination — specify IP address that will substitute Destination IP
Address of an Ethernet frame.
• Replace — select the mode of ToS swapping:
– Off — swapping of Type of Service and Precedence values is dis-
abled;
– ToS — swap Type of Service values;
– Precedence — swap Precedence values;
Bercut-ET. Operations manual