metrotek Bercut-ET, Руководство по эксплуатации

Страница: 108 / 116

108 Remote control commands
Table B.2. Remote management commands (TELNET). Show mode (continued)
show network gateway
show gateway IP address
show network dns show DNS IP address
TCP/IP testing
ping start ping test
Common commands
exit exit the command mode
reboot reboot the analyzer
help show the list of available commands
configure switch to the configuration mode
show version show firmware number
Table B.3. Remote control commands (TELNET). Configuration mode
Command Operation
RFC 2544
rfc2544 header src udp text set source UDP-port number
rfc2544 header src mac XX:XX:XX:XX:XX:XX set source MAC address
rfc2544 header src ip i.i.i.i set source IP address
rfc2544 header dst udp text set destination UDP-port number
rfc2544 header dst mac XX:XX:XX:XX:XX:XX set destination MAC address
rfc2544 header dst ip i.i.i.i set destination IP address
rfc2544 header vlan enabled off/on enable/disable VLAN parameter
rfc2544 header vlan id text set VLAN identifier
rfc2544 header vlan prior text set traffic priority
rfc2544 header precedence text set frame priority
rfc2544 header tos 0000 / 1000 / 0100 / 0010 / 0001 set type of service for the packet
rfc2544 topology port tx a/b set data transmitting port
rfc2544 topology port rx a/b
set data receiving port
rfc2544 frames user enabled no/yes
enable/disable user-defined frame
size
rfc2544 frames 1 text
rfc2544 frames 2 text
rfc2544 frames 3 text
rfc2544 frames 4 text set arbitrary frame size
rfc2544 frames 5 text
rfc2544 frames 6 text
rfc2544 frames 7 text
rfc2544 frames 8 text
rfc2544 throughput duration text
set trial duration for the throughput
analysis
rfc2544 throughput enabled no/yes
enable/disable throughput analysis
Bercut-ET. Operations manual