metrotek Bercut-ET, Руководство по эксплуатации

Страница: 99 / 116

6.1 Management in the Terminal mode 99
2. Type in
ATR
command.
Select MCU .
In the Transfer
⇒
Send File menu of
HyperTerminal
utility, specify
the path to a MCU program file (with
.bin
extension) in the Filename
window; and select the
Xmodem
in the Protocol window. Click Send .
Estimated duration of the update procedure is 1 minute. If the da-
ta displayed previously on the screen has been restored, the update is
completed successfully.
Note:
if MCU program version is not compatible with versions of the
system FPGA and expansion FPGA microcodes, then you will get a warning
message and the expected version number. In this case, the expected version
should be installed instead of the current version.
Note: when FPGA microcodes and MCU are updated, it is recommended
to press the hardware restart button with any thin blunt pin. The button is
next to the 12V power supply connector on the side panel.
6.1.2.3 Updating file system
1. Connect the Bercut-ET to PC via USB (see section 6.1.1).
Check the connection using
AT
command.
2. Type in
ATR
command.
Select FS image .
In the Transfer ⇒ Send File menu of
HyperTerminal
utility, specify
the path to a MCU program file (with
.bin
extension) in the Filename
window; and select the
Xmodem
in the Protocol window. Click Send .
Estimated duration of the update procedure is 5 second. If the da-
ta displayed previously on the screen has been restored, the update is
completed successfully.
Bercut-ET. Operations manual