Metro Therm SHK 200S, Инструкция по установке и эксплуатации

Страница: 6 / 80

6 SHK 200S
SHK 200S-6
2 Supply and operation
Transport Included items
Assembly
SHK 200S / SHK 200S-6 heat pump must be transport-
ed and stored vertically in a dry place. SHK 200S / SHK
200S-6 can be, however, carefully placed on the rear side
of the casing when carrying the device into the building.
Leave 800 mm free space at the front of the heat
pump. All maintenance works on SHK 200S / SHK
200S-6 can be done from the front.
The side covers and rear wall of the housing are per-
manently attached, therefore it is not possible to dis-
mantle them.
• SHK 200S / SHK 200S-6 must be set on a solid
waterproof base that would keep the weight of the
indoor unit. The regulated legs of the heat pump
allow for levelling and stable setting of the device.
• Because SHK 200S / SHK 200S-6 is equipped
with condensate drain, indoor unit installation site
must be furnished with a fl oor drain with a dis-
charge to the sewer system.
1. Remove screws at the bottom edge of the front cover.
2. Open the cover at the lower edge, taking care to
not damage the connecting cables, and then re-
move the front cover by lifting it up.
3. Disconnect the cable connecting the front cover
to the unit.
Installation site
Removal of the covers
3
Chapter 2 | Supply and operation
20-40 mm
Wrench size 13
IMPORTANT
When using an additional heat source, leave behind
the device the space necessary for non trouble free
connections and subsequent maintenance.
25-30 mm
800 mm
IMPORTANT
The opening pressure of the safety valve is 3 bar.
Safety group with safety
valve (3 bar), pressure
gauge and automatic air
vent (1 pc.)
Temperature sensor
Outdoor / indoor
(2 pcs)
Connection p.27
• Safety group (1 pc.)
• Outdoor / indoor temperature sensor (1 pc.)
• Instalation and user manual