Metro Therm SHK 200S, Инструкция по установке и эксплуатации

Страница: 48 / 80

48 SHK 200S
SHK 200S-6
Factory setting:
CAUTION
It cannot be set "stop additional heat" higher than "stop
heating".
CAUTION
After factory setting, personal settings such as heating
curves must be reset.
CAUTION
In systems where heating and cooling share the same
pipes "stop heating" cannot be set higher than "start
cooling" if there is not a cooling/ heating sensor.
CAUTION
Higher value on "start compressor" gives more com-
pressor starts, which increase wear on the compressor.
Too low value can give uneven indoor temperatures.
CAUTION
Long term blocking can cause reduced comfort and op-
erating economy.
Menu 4.9.3 - degree minute setting
Menu 4.9.4 - factory setting user
Menu 4.9.5 - schedule blocking
Degree minutes are a measurement of the current
heating requirement in the house and determine when
the compressor respectively additional heat will start/
stop. More information after selecting "
?".
All settings that are available to the user (including ad-
vanced menus) can be reset to default values here.
More information after selecting "
?".
The compressor can be scheduled to be blocked for
up to two different time periods here. When scheduling
is active the actual blocking symbol in the main menu
on the heat pump symbol is displayed. More informa -
tion after selecting "?".
Factory setting:
current value 100 DM
start compressor: -60 DM
start diff additional heat: 400 DM
diff. between additional steps: 30 DM
ADVICE
If you wish to set similar scheduling for every day of
the week start by filling in “all” and then changing the
desired days.
ADVICE
Set the stop time earlier than the start time so that
the period extends beyond midnight. Scheduling then
stops at the set stop time the day after.
Scheduling always starts on the date that the start time
is set for.