Metro Therm SHK 200S, Инструкция по установке и эксплуатации

Страница: 11 / 80

11 SHK 200S
SHK 200S-6
Indoor SHK 200S / SHK 200S-6 module
• It is recommended that the SHK 200S / SHK
200S-6 module should be installed in a room with
a floor drain, at best in a utility room or a boiler
house.
• The floor must be solid, concrete at best.
• The SHK 200S / SHK 200S-6 module must be set
with its back to the outer wall, at best in a room
where noise is not a problem. If possible, do not
place the device near a wall of a bedroom or an-
other room where noise might be a problem.
• The device can be leveled using regulated legs.
• Pipes must be led in such a way that they are not
adjacent to the bedroom or living room.
• Remember to leave about 800 mm free space at
the front and 220 mm over the device to provide
for future maintenance.
1. Connect SHK 200S / SHK 200S-6 module to the
heating system, cold, and hot water pipelines.
2. Install the cooling medium pipes.
3. Connect the outdoor temperature sensor, and
cables between SHK 200S / SHK 200S-6 and
METROAIR L.
4. Connect power supply to module SHK 200S /
SHK 200S-6.
5. Proceed according to start-up instructions in
chapter Start-up and regulation.
Recommended order of assembly
P
SHK 200S
SHK 200S-6
XL10
XL18 XL19
XL1
XL2
-EB101
-BT1
HS1 -BP4
-BT15
-BT3
-GP12
-BT64
-BT25
-QN12
-BT63
-BT71
-QN10
-BT7
-BT6
P
Scheme with the connection of an additional heat source
Chapter 4 | Pipe connections