Metal-Fach Z562, Инструкция по эксплуатации, Страница: 9 / 52

INSTRUCTION MANUAL
– BALER Z562
9
Description of control-panel push buttons
Switch
– press and hold to activate the counter. Press once again to switch the
counter off.
Applicator
– switch on/off the applicator. Press the key to switch the
applicator on. Press once again to switch the applicator off. The green
indicator lamp means that the applicator is running.
Binding
– switch on/off the binding. Press and hold the key to activate
the unit. Release the key to switch the bale-binding unit off. The green
indicator lamp means that the bale-binding unit is running.
Hydraulic manifold
– press the key to switch on the hydraulic
manifold. After the pre-set delay time, the manifold is activated
automatically. Press the key again before the pre-set delay time has
passed to deactivate the manifold action. The green indicator lamp
means that the hydraulic manifold is running.
Deleting
– press and hold the key to delete the workday counter data.
Description of the signalling fields
The red indicator lamp means that the chamber is overloaded.
The yellow indicator lamp means that the chamber has been opened.
3.5.1 Switching on the panel
Connect the counter mounted in the operator's cab to the baling press by means of the
D-SUB 9-pin coupling. Do not use excessive force to plug in. Secure the correctly connected
plug from accidental disconnection by tightening the retaining bolts located on both sides of
the plug. Correct connection is c
onfirmed by a flashing red dot on the display. After the “On/Off”
switch (
“Włącznik”
) key has been pressed, the control panel does a display test and checks
the supply voltage. The counter display shows “
8.8.8.8.
”, all the indicator lamps light up, and
the acoustic signal can be heard. Then, the message “
U12.2
” is displayed which gives the
voltage of the counter-supply system (it means the voltage of 12.2V).