Metal-Fach Z562, Инструкция по эксплуатации, Страница: 30 / 52

30
INSTRUCTION MANUAL
– BALER Z562
4.11 Adjusting The Twine-Binding Device
Adjust the width of bale twine-binding with limit stops located on both sides of the twine
feeder. Setting the limit stops towards the centre of the baler results in the binding of the middle
part of a bale. The greatest extension of the stops results in bending the maximum length of a
bale. Change the binding density by changing the twine path on wheel B.
The binding density increases along with the increase in the wheel B diameter (Figure
16). The highest binding density is obtained by running the twine with the wheel of the biggest
diameter.
Clean the inside of the twine feeder in the place shown in Figure 16 by removing dust
and blowing it with a low-pressure air after lifting the twine feeder cover. Direct the dirt towards
the outlet.
4.11.1 Sharpening The Twine Blades
You can sharpen the blade as shown in Figure 16. To dismantle the twine-cutting blade,
loosen the bolts (3). After sharpening, secure the blade with the bolts (3).
4.12 Adjusting The Net-Binding Device
You can set the length of the bale binding with the adjusting screw (Figure 41). Tighten
the adjusting screw to move the measurement blade (13) further from the belt wheel (12), and
decrease the binding length, as shown in Figure 41. Determine the number of binding turns
ccording to the harvest condition. The m
anufacturer’s recommended number of binding turns
is 1.5 to 2.5 bale turns.
Figure 41. Adjusting the bind counter - the adjusting screw
Adjustment screw
WARNING!
Clean the inside of the twine feeder after each finished work
WARNING