Metal-Fach Z562, Инструкция по эксплуатации, Страница: 43 / 52

INSTRUCTION MANUAL
– BALER Z562
43
5 Possible Faults
The most-frequent faults and problems which can occur during machine operation are
presented in the table below. If the suggested solutions fail to bring the required result, contact
the distributor or service centre of Metal-Fach.
Table 5 Possible faults
Pick-up
Problem Possible cause Solution
Clogging the inlet of the
chamber. Too-large and/or irregular
windrows or too-high a working
speed. Form the windrows of the right
size and/or work at a lower
pick-up speed.
Excessive picking up of
windrow on one of the sides of
the pick-up. Drive the baler equally from
one side to the other.
Too low a rotational speed
(rpm). Work with a rotational speed of
540 rpm.
The pick-up tines tear the
material Too-high a rotational speed of
the pick-up compared to the
working speed. Increase the working speed.
Decrease the PTOff rpm.
The pick-up tines miss parts of
the windrow. Too low a rotational speed of the
pick-up compared to the working
speed. Decrease the working speed.
Increase the PTOff rpm.
The pick-up does not collect all
the windrow. Too-large a windrow width. Form new, narrower, windrows.
The pick-up does not collect
windrow from level ground. The pick-up is set too high. Lower the pick-up position.
Set the pick-up wheels correctly.
The pick-up lets the material
pass and stops. The protection component is
defective. Halve the volume of the windrow.
Adjust the wheel position to lift
the pick-up.
Remove the accumulated plant
material and replace the
protective component.
Insufficient windrow pick-up. The pick-up tines are lost or
damaged. Replace the pick-up tines.