X
Turn the key to position 2 in the ignition
lock.
X
Press the transmitter button on the rear-
view mirror that you have programmed to
operate the garage door.
Garage door system with fixed code: indi-
cator lamp
:
lights up continuously.
Garage door system with rolling code: indi-
cator lamp
:
flashes briefly and then lights
up for approximately two seconds. This is
repeated for up to 20 seconds.
i
The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. The transmission will be halted
after a maximum of 20 seconds and indi-
cator lamp
:
will flash. Press the trans-
mitter button again, if necessary.
Clearing the remote control memory
X
Turn the key to position 2 in the ignition
lock.
X
Press and hold transmitter buttons
;
and
?
for approximately 20 seconds until
indicator lamp
:
flashes rapidly.
The memory is cleared.
i
You should clear the remote control mem-
ory before selling the vehicle.
Floormat* on the driver's side
G
Risk of accident
Make sure that there is sufficient clearance
around the pedals when floormats are used,
and that the floormats are properly secured.
The floormats must be correctly secured at all
times using retainers and press-studs.
Before you drive off check the floormats and
secure if necessary. A floormat which is not
properly secured can slip and, thereby, inter-
fere with the movement of the pedals.
Do not place floormats on top of one another.
X
Slide seat backwards.
X
To fit: place the floormat in position.
X
Press studs
:
onto retainers
;
.
X
To remove: pull floormat off retainers
;
.
X
Remove the floormat.
308
Features
Contr
ols
* optional
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 308
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:18:21; WK
