of the headphones by pulling the head-
phone band in the direction of the arrow.
X
To switch the headphones on/off: press
button
?
.
To preserve the batteries, the headphones
automatically switch off if they have not
received an infrared signal for approx-
imately three minutes.
X
To set the volume: turn volume con-
trol
:
until the desired volume is set.
i
If you have connected wired headphones
to a rear-compartment screen, you can
adjust the volume by pressing buttons
C
on the remote control (
Y
page 65).
X
To select the screen: slide switch
;
to
L (left-hand screen) or R (right-hand
screen).
Wired headphones
:
Socket for wired headphones
;
V jack for video signal
=
L jack for audio signal, left
?
R jack for audio signal, right
You can connect an additional set of wired
headphones to each rear-compartment
screen. The socket is designed for head-
phones with a 3.5 mm stereo jack plug and
an impedance of 32 ohms.
Basic functions
i
Information about the components and
operating principles of COMAND can be
found on (
Y
page 62).
Switching COMAND on/off
X
Press the
u
button.
i
If you switch off COMAND, playback of
the current audio or video source will also
be switched off. You cannot switch off
COMAND while making a call* via
COMAND.
Sound
X
To switch on/off: press the
8
button
on the multi-function steering wheel.
The sound from the respective audio or
video source is switched on or muted.
i
When the audio output is switched off, the
status line will show the
8
symbol. If
you switch the audio or video source, the
audio output is automatically activated.
You will still hear traffic announcements
and navigation system announcements*,
even if the sound is muted.
Muting traffic and navigation announce-
ments*
X
RDS: press and hold the
8
button on
the multi-function steering wheel until the
TA
display switches off.
X
Navigation announcements: during an
announcement, press the
8
button on
the multi-function steering wheel.
i
The announcements remain switched
off even if you start a new route guidance
or if COMAND is switched off and on with
the
u
button. They will be switched on
again under the following conditions: if you
switch COMAND off by removing the key
from the ignition lock and then switch the
ignition back on after more than 3 minutes.
Introduction
67
COMAND
* optional
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 67
Z
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:16:57; WK
