Remote control in the rear-view mirror
G
Risk of accident
Only press the transmitter button on the inte-
grated remote control if there are no persons
or objects present within the sweep of the
garage door. Persons could otherwise be
injured as the door moves.
Programming the remote control
i
You will achieve the best results by insert-
ing new batteries in the garage door's
remote control before programming it.
X
Erase the memory of the integrated remote
control (
Y
page 308) before programming
it for the first time.
X
Turn the key to position 2 in the ignition
lock.
X
Press and hold one of transmitter but-
tons
;
to
?
on the integrated remote
control.
Indicator lamp
:
starts to flash after a
short while. It flashes about once a second.
i
Indicator lamp
:
flashes immediately
the first time the transmitter button is pro-
grammed. If this transmitter button has
already been programmed, indicator
lamp
:
will only start flashing at a rate of
once a second after 20 seconds have
elapsed.
X
Keep the transmitter buttons depressed.
X
Point the garage door's remote control with
the transmitter towards the left-hand side
of the rear-view mirror from a distance of 5
to 20 cm.
i
The distance between the garage door's
remote control and the integrated garage
door opener depends on the system of the
garage door drive. You might require sev-
eral attempts. You should test every posi-
tion for at least 20 seconds before trying
another position.
X
Keep the transmitter button on the garage
door's remote control depressed until indi-
cator lamp
:
starts to flash rapidly.
The programming was successful if indica-
tor lamp
:
flashes rapidly.
X
Release the transmitter buttons on the
garage door's remote control and the inte-
grated remote control.
If indicator lamp
:
goes out after approx-
imately 20 seconds and did not flash rapidly
before this:
X
Release the transmitter buttons on the
integrated and portable remote controls.
X
Repeat the programming procedure. When
doing so, change the distance between the
garage door's remote control and the trans-
mitter buttons in the rear-view mirror.
i
If the garage door system works with a
rolling code, after programming you must
synchronise the remote control integrated
in the rear-view mirror with the garage door
system receiver.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on "Synchro-
nising the transmitter" or "Registering a
new transmitter". You can also call the hot-
line mentioned above.
Opening or closing the garage door
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please read
the operating instructions for the garage door
system.
Features
307
Cont
ro
ls
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 307
Z
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:18:20; WK
