Mobile phone operational
The multi-function display shows the
Tele‐
phone ready
message or the name of the
GSM network provider. If your vehicle is out-
side the transmission and receiver range, the
multi-function display shows the
No
service
message.
Accepting a call
If someone calls you while you are in the
Telephone
menu, a message appears in the
multi-function display, for example:
X
Press the
6
button to accept the call.
If you are not in the
Telephone
menu, you can
still accept a call.
Rejecting/ending a call
X
Press the
~
button.
If you are not in the
Telephone
menu, you can
still accept a call.
Dialling a number from the phone book
You can use the mobile phone to enter new
telephone numbers into the phone book (see
COMAND (
Y
page 128)). If your mobile phone
is operational, you can select and dial a num-
ber from the phone book at any time.
When you insert the mobile phone into the
mobile phone bracket or establish a Blue-
tooth connection to COMAND, COMAND
imports the phone book from the mobile
phone. This can take some time.
While the on-board computer reads in the SIM
card:
R
you can dial a telephone number from the
redial memory (
Calls dialled
list).
R
you can dial a telephone number from the
telephone book stored in COMAND.
R
the multi-function display shows the
Read‐
ing data...
display message below the
phone book entries.
When the multi-function display shows the
display message
Updating data...
,
COMAND has finished importing data. The
multi-function display then shows all the
phone book entries in COMAND and the
mobile phone.
X
Press the
=
or
;
button to select the
Telephone
menu.
X
Press the
:
,
9
or
a
button to call
up the phone book.
X
Press the
:
or
9
button to select the
desired name.
To scroll rapidly, press and hold the
:
or
9
button for longer than one second.
After passing through eight entries, the
rapid scroll speeds up.
Rapid scrolling stops when you release the
button or reach the end of the list.
X
If several telephone numbers are stored for
one name
G
: use
a
or
6
to open
the list of stored numbers and press
:
or
9
to select the desired telephone
number.
X
Press the
6
or
a
button to start dial-
ling.
The number dialled is stored in the redial
memory.
The telephone number dialled appears in
the multi-function display. If the name is
238
On-board computer
Controls
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 238
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:17:51; WK
