Installing the map data
Just before the copying process starts,
COMAND restarts the system.
While the installation is running, you will see
a message to this effect and a progress bar.
X
To cancel an installation process on the
single DVD drive: press the eject button.
X
Take the DVD out of the slot.
X
To cancel an installation process on the
DVD changer: press the corresponding
magazine tray button.
X
Take the DVD out of the slot.
i
If you interrupt the installation process,
the navigation system will not be opera-
tional. You can continue an interrupted
installation process at a later date.
X
Installation process with multi DVD
map data: once the content of the first
DVD has been installed, a message appears
prompting you to insert the second DVD.
Follow the instructions on the display.
X
To allow the installation process to run
to the end without cancelling: take no
further action.
When the installation process is success-
fully completed, you will see a message to
this effect.
X
To confirm the message: press
W
.
COMAND ejects the DVD.
X
Take the DVD out of the slot.
The installation process is complete.
When the installation process is successfully
completed, you will see a message to this
effect.
X
To confirm the message: press
W
.
COMAND ejects the DVD.
X
Take the DVD out of the slot.
If the installation process cannot be success-
fully completed, this may be due to the fol-
lowing:
R
DVD dirty or scratched
X
Clean the DVD (
Y
page 141).
X
Restart the map software installation
process.
R
Overheating due to excessive tempera-
tures in the vehicle interior.
X
Wait until the vehicle interior has
cooled down.
X
Restart the map software installation
process.
R
If the measures listed above do not solve
the problem:
X
Consult a Mercedes-Benz Service
Centre.
Navigation system* (entering a desti-
nation)
Introduction to entering destinations
The following destination input options are
available:
R
entering a destination by address
R
entering a destination from the destination
memory
R
entering a destination from the list of last
destinations
R
entering a destination using the map
R
entering an intermediate stop
R
entering a special destination
Entering a destination by address
i
In certain countries, it is not possible to
enter an address if the vehicle is travelling
at more than approximately 5 km/h. As
soon as the vehicle speed drops below
about 3 km/h, the function is available
again.
Navigation system* (entering a destination)
143
CO
MA
ND
* optional
221_AKB; 2; 3, en-GB
bjanott,
Version: 2.11.7.7
2009-02-27T14:56:10+01:00 - Seite 143
Z
Dateiname: 6515231002_buchblock.pdf; erzeugt am 03. Mar 2009 15:17:18; WK