Mendota FV44I Gen 3, Инструкция по сборке, установке и эксплуатации

Страница: 55 / 98

85-03-01060-D FV44i Décor Gen 3 Page 55
4.7 LEVELING BOLTS
4.7.1 Leveling Bolts Definition
Four leveling bolts are included in the manual package. The leveling bolts allow for a ¼” minimum to 1” maximum leveling ability.
Leveling bolts are designed to adjust for uneven fireplace floors and yield plumb Insert Body. Use the leveling bolts only if the
fireplace floor is more than ¼” out of level from one side to another or from front to back. If the fireplace floor is less than ¼” out
of level, use metal sheet shims in various thickness and build up to needed leveling thicknesses at various points around the
appliance.
The leveling bolts supplied are designed specifically for application with this product. only use leveling bolts supplied by Mendota
and for leveling purposes only. Never use leveling bolts for purposes of lifting unit up to make up for ash lip heights or other
lifting or raising needs. Such use can cause extreme thermal expansion of firebox floor and can result in oil canning noise or
louder thermal expansion and constriction banging noise.
SUCH NOISE PROBLEMS ARE NOT COVERED UNDER MENDOTA
WARRANTY
Note: When lifting this Insert more than 1”, other support blocks will be required. For all applications when
you raise the unit more than 1”, reline the entire firebox floor with refractory bricks to build up a full level
floor for the Insert to sit on. Do not use individual support block only under the four corners of this unit.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in propert y damage or personal injury. Never use other
after-market leveling bolts. Doing so can lead to vibration noise problems or damage to internal
components.DO NOT USE LONGER BOLTS TO LIFT INSERT UPWARD. THIS CAN CAUSE OTHER SIDE EFFECTS LIKE
HEAT EXPANSION/CONTRACTION NOISES. To lift Insert up, use Firebricks and mortar or a metal box designed
specifically for this purpose .
4.7.2 Leveling Bolts Installation
Perform this step after you have measured the firebox floor for level surface characteristics. Tip the Insert body on its back on
the wooden pallet. Thread one leveling bolt in to each leveling bolt receiving fastener. Thread the bolt in as far as necessary to
achieve the leveling effect desired.
Figure 4-7 Leveling Bolts Installation