Megger PVS 100i, Руководство пользователя

Страница: 8 / 47

8
2 Quick start
Purpose The following quick start guide is intended to enable you to put the PVS 100i into operation
and perform initial measurements without a great deal of training. In this guide, only the
really necessary operating steps and settings are described.
To learn more about the full range of system functions, it is therefore mandatory to also
read the following sections of the manual.
Starting up the base
station (once only)
Preparing the
mobile unit for use
in measuring (once
only)
Phase identification
with the mobile unit
1
Configuration Settings
Mode = Base
(see page Fehler! Textmarke nicht definiert.
f d t il )
2
Put the base station into operation by plugging it into any network socket and check that GSM and GPS
reception is ensured (see page Fehler! Textmarke nicht definiert. for details). The unit should then
remain plugged into this socket exclusively so that the measurement profiles retain their validity.
3
Configuration Settings
Mode = Mobil
(see page Fehler! Textmarke nicht definiert.
f d t il )
4
Configuration
Settings
Enter phone number of base
(see page Fehler! Textmarke nicht definiert.
f d t il )
5
Create a measurement profile for every measurement scenario that arises in the mobile unit's area of
application if possible (see page Fehler! Textmarke nicht definiert. for details)
Connect mobile unit with known phase L1
(see page Fehler! Textmarke nicht definiert. for details)
Check that GSM and GPS reception
is ensured
Configuration
Select how the
voltage is tapped
New profile
Select the type of
power supply 0 Stop Save profile
6
Connect mobile unit with phase to be identified
(see page Fehler! Textmarke nicht definiert. for details)
Check that GSM and GPS
reception is ensured
Select the appropriate
measurement profile
Select the type of
power supply
Read off phase